Polymoog Resonator_JML

---

Description

Based on the Resonator section of a Moog Polymoog, this module is an optimized recreation of a BC Modular patch developed by jhulk.

Type

FILTER

Module

Popup

S|C Equivalent

not really, but see also

(OSC)

Module Connections

Label	Type	Description	Control Range
Type	Async	Value in to setting the Filter Mode	Multimode
Drive	Async	Value in controlling the Saturation	%
Freq1-3	Async	Value in controlling the Cutoff	hz
Gain1-3	Async	Value in controlling the Gain Filter Level	db
Q1-3	Async	Value in controlling the Emphasis	reso
in	Audio In	Audio input
out	Audio Out	Audio output

Popup Controls

Label	Description
TYPE	Filter Mode
DRIVE	Warm Overdrive
FREQ	All Value of 3x Frequency

Screen

Storyboard

Here's a patch sharc was sent a while back by jhulk. It's based on the Resonator section of a Polymoog...
As you can see, the patch has been created inside a CLM module and because it's a filter circuit jhulk has locked it to 1DSP so as to keep latencies in check.

While the CLM can be saved as a new module it is unfortunately rather bulky and this circuit weighs in at approximately 1.7MB in comparison to other much leaner BC Modular modules. Also, because the whole circuit has been locked to 1DSP it can only handle 4voices if you were to use it polyphonically.



However, since this patch was built entirely using BC Modular modules it wasn't too difficult for me to recreate as an optimized BC Modular module complete with popup control panel.

This module weighs in at 53KB and can handle 14 voices of polyphony... BC Forum